A Unified Cutting Force Model for Flat End Mills Based on Cutter Geometry and Material Properties

E-ISSN： 1662-9752|2016|836|408-416

ISSN： 0255-5476

Source： Materials Science Forum, Vol.2016, Iss.836, 2016-02, pp. : 408-416

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Development of dislocation-based unified material model for simulating microstructure evolution in multipass hot rolling

By Lin J.

Philosophical Magazine, Vol. 85, Iss. 18, 2005-06 ,pp. : 1967-1987

Taylor & Francis Ltd

Access to resources Recommend Favorite

Identification of Cutting Shear Stress, Shear and Friction Angles Using Flat End Milling Tests

Materials Science Forum, Vol. 2016, Iss. 836, 2016-02 ,pp. : 112-116

Trans Tech Publications

Access to resources Recommend Favorite

Force decomposition model for tool-wear in turning with grooved cutting tools

By Ee K.C. Balaji A.K. Li P.X. Jawahir I.S.

Wear, Vol. 249, Iss. 10, 2001-11 ,pp. : 985-994

Elsevier

Access to resources Recommend Favorite

Influence of Cutting Parameters and Tool Geometry on Thrust Force Behavior in Drilling Ti6Al4V

Materials Science Forum, Vol. 2016, Iss. 862, 2016-09 ,pp. : 3-10

Trans Tech Publications

Access to resources Recommend Favorite

Estimation of Machining Error Caused by Deflection of Tool Using Cutting Force in Ball End Milling of Inclined Surface

Materials Science Forum, Vol. 2016, Iss. 874, 2016-11 ,pp. : 525-530

Trans Tech Publications

Access to resources Recommend Favorite