Finite Element Deformation Analysis of Long Thin Cantilever Shape Parts in High Speed Ball End Milling of Titanium Alloy Ti-6Al-4V with PCD Tools at Various Tool Inclination Angles

Publisher： Trans Tech Publications

E-ISSN： 1662-9795|2016|693|1038-1045

ISSN： 1013-9826

Source： Key Engineering Materials, Vol.2016, Iss.693, 2016-06, pp. : 1038-1045

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Air Jet Assisted End Milling of Titanium Alloy Ti-6Al-4V ELI at High Cutting Speed

By  

Key Engineering Materials, Vol. 2015, Iss. 656, 2015-08 ,pp. : 168-173

Trans Tech Publications

Access to resources Recommend Favorite

Influence of damping coefficient from permanent magnets on chatter formation during end milling of titanium alloy (Ti-6Al-4V)

By  

IOP Conference Series: Materials Science and Engineering, Vol. 100, Iss. 1, 2015-12 ,pp. : 521-529

IOP Publishing

Access to resources Recommend Favorite

Finite Element Analysis on Single Abrasive Grinding Ti6Al4V Alloy

By  

Key Engineering Materials, Vol. 2018, Iss. 764, 2018-03 ,pp. : 184-193

Trans Tech Publications

Access to resources Recommend Favorite

Powder Injection Molding of Ti-6Al-4V Alloy for Defect-Free High Performance Titanium Parts with Low Carbon/Oxygen Contents

By  

Key Engineering Materials, Vol. 2018, Iss. 770, 2018-07 ,pp. : 189-194

Trans Tech Publications

Access to resources Recommend Favorite

Research on Milling Deformation in Ultrasonic Vibration Assisted End Milling of Titanium Alloy Thin-Walled Parts

By  

Key Engineering Materials, Vol. 2018, Iss. 764, 2018-03 ,pp. : 174-183

Trans Tech Publications

Access to resources Recommend Favorite