Determination of the Bending Strength Geometry Factor J for the Calculation of Stress in Parallel-Axis Gears as a Function of the Reference Correction and Slope Angle of the Gear Tooth

Publisher： Ethan Publishing Company

E-ISSN： 2333-9187|3|1|27-33

ISSN： 2333-9179

Source： International Journal of Mechanical Engineering and Automation, Vol.3, Iss.1, 2016-01, pp. : 27-33

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Method for Precision Calibration of Rotary Scale Errors and Precision Determination of Gear Tooth Index Errors

By Mark W.D.  

Mechanical Systems and Signal Processing, Vol. 12, Iss. 6, 1998-11 ,pp. : 723-752

Academic Press

Access to resources Recommend Favorite

Influence Gearing Parameters on the Tooth Deformation of Spur Gears

By  

Applied Mechanics and Materials, Vol. 2015, Iss. 816, 2015-12 ,pp. : 27-30

Trans Tech Publications

Access to resources Recommend Favorite

Numerical Determination of the LMTD Correction Factor for Shell-and-Tube 1-2 Heat Exchangers

By  

Applied Mechanics and Materials, Vol. 2015, Iss. 789, 2015-10 ,pp. : 457-461

Trans Tech Publications

Access to resources Recommend Favorite

Numerical Procedure for LMTD Correction Factor Calculation for One Tube and One Shell Pass Shell-and-Tube Heat Exchangers

By  

Applied Mechanics and Materials, Vol. 2015, Iss. 789, 2015-10 ,pp. : 426-429

Trans Tech Publications

Access to resources Recommend Favorite

Use of the Moving Cepstrum Integral to Detect and Localise Tooth Spalls in Gears

By Badaoui M.E.   Antoni J.   Guillet F.   DANIÈRE J.   Velex P.  

Mechanical Systems and Signal Processing, Vol. 15, Iss. 5, 2001-09 ,pp. : 873-885

Academic Press

Access to resources Recommend Favorite