Wear rate and surface morphology of UHMWPE cups are affected by the serum lubricant concentration in a hip simulation test

Author： Liao Y.-S. McNulty D. Hanes M.

Publisher： Elsevier

ISSN： 0043-1648

Source： Wear, Vol.255, Iss.7, 2003-08, pp. : 1051-1056

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Related content

Validation of volumetric and linear wear-measurement in UHMWPE cups-a hip simulator analysis

By Masaoka T. Clarke I.C. Yamamoto K. Tamura J. Williams P.A. Good V.D. Shoji H. Imakiire A.

Wear, Vol. 254, Iss. 5, 2003-03 ,pp. : 391-398

Elsevier

Access to resources Recommend Favorite

Three-body wear of UHMWPE acetabular cups by PMMA particles against CoCr, alumina and zirconia heads in a hip joint simulator

By Wang A. Essner A.

Wear, Vol. 250, Iss. 1, 2001-10 ,pp. : 212-216

Elsevier

Access to resources Recommend Favorite

Mechanical behavior, wear surface morphology, and clinical performance of UHMWPE acetabular components after 10 years of implantation

By Edidin A.A. Rimnac C.M. Goldberg V.M. Kurtz S.M.

Wear, Vol. 250, Iss. 1, 2001-10 ,pp. : 152-158

Elsevier

Access to resources Recommend Favorite

The effect of lubricant selection on galling in a model wear test

By van der Heide E. Huis in 't Veld A.J. Schipper D.J.

Wear, Vol. 251, Iss. 1, 2001-10 ,pp. : 973-979

Elsevier

Access to resources Recommend Favorite

The quantitative assessment of UHMWPE wear debris produced in hip simulator testing: the influence of head material and roughness, motion and loading

By Elfick A.P.D. Smith S.L. Green S.M. Unsworth A.

Wear, Vol. 249, Iss. 5, 2001-06 ,pp. : 517-527

Elsevier

Access to resources Recommend Favorite