Effect of Shrinkage on Primary Dendrite Arm Spacing during Binary Al-Si Alloy Solidification

ISSN： 1543-1940

Source： Metallurgical and Materials Transactions A, Vol.42, Iss.8, 2011-08, pp. : 2331-2345

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Effect of dendrite arm spacing on cleavage fracture toughness of Al–5Si–1Cu alloy

By Wierzbińska M. Sieniawski J.

International Journal of Cast Metals Research, Vol. 17, Iss. 5, 2004-10 ,pp. : 267-270

Maney Publishing

Access to resources Recommend Favorite

Correlation between Thermal Parameters, Primary Dendrite Arm Spacing and Microhardness on a Directionally Solidified Ternary Al-6wt%Cu-8wt%Si Alloy

Defect and Diffusion Forum, Vol. 2015, Iss. 365, 2015-08 ,pp. : 136-141

Trans Tech Publications

Access to resources Recommend Favorite

Response of primary dendrite spacing to varying temperature gradient during directional solidification

By Ma Dexin

Metallurgical and Materials Transactions B, Vol. 35, Iss. 4, 2004-08 ,pp. : 735-742

Springer Publishing Company

Access to resources Recommend Favorite

Modeling of primary spacing selection in dendrite arrays during directional solidification

By Ma Dexin

Metallurgical and Materials Transactions B, Vol. 33, Iss. 2, 2002-04 ,pp. : 223-233

Springer Publishing Company

Access to resources Recommend Favorite

The heat-transfer coefficient during the unidirectional solidification of an Al-Si alloy casting

By Griffiths W.

Metallurgical and Materials Transactions B, Vol. 30, Iss. 3, 1999-06 ,pp. : 473-482

Springer Publishing Company

Access to resources Recommend Favorite