Interdependence of Distortion and Residual Stress Relaxation of Cold-Rolled Bearing Rings During Heating

ISSN： 1543-1940

Source： Metallurgical and Materials Transactions A, Vol.42, Iss.5, 2011-05, pp. : 1205-1214

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

This article discusses the distortion behavior during heating of bearing rings produced by cold rolling. The residual stress relaxation was characterized intensively and correlated to the distortion behavior. In the initial state, the rings show compressive residual stresses in tangential and axial direction with almost no variations along the circumference. Because of the cold-rolling process, the entire cross section is affected by residual stresses. The rings present a characteristic size change between the soaking temperatures 773 K and 823 K (500 °C and 550 °C), which can be correlated with the macroresidual stress relaxation in the core of the rings. Changes in roundness deviation were found, but the amplitude of oval and triangular shape increases continuously until austenitizing temperature is reached. As the macrostress relaxation is already completed at 873 K (600 °C), another mechanism should be responsible for these distortions. A correlation between amplitude of the oval shape and decrease of full width at half maximum seems to be present. This may indicate that inhomogeneous recrystallization happens along the circumference of the rings. A triangular shape may result from the influence of the loading tool used as rings are positioned on three contact points during the stress relief treatment.