Parametric conditions of defect-free molding of mass produced powder material objects in hydraulic type press equipment

ISSN： 0009-2355

Source： Chemical and Petroleum Engineering, Vol.46, Iss.11-12, 2011-03, pp. : 677-685

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Analysis of the Hydraulic Resistance of Vortex Equipment

By Tarasova L. A. Terekhov M. A. Troshkin O. A.

Chemical and Petroleum Engineering, Vol. 40, Iss. 1-2, 2004-01 ,pp. : 83-86

Springer Publishing Company

Access to resources Recommend Favorite

Processes and Equipment for Chemical and Oil-Gas Production: Hydrodynamics of the bubbling layer in a new type of combined heat and mass exchanger

By Ivanov A. Berengarten M. Klyushenkova M.

Chemical and Petroleum Engineering, Vol. 46, Iss. 7-8, 2010-11 ,pp. : 433-440

Springer Publishing Company

Access to resources Recommend Favorite

Method for molding fibreglass objects based on polymer binder electrophysical treatment

By Erenkov O. Ivakhnenko A. Radchenko M.

Chemical and Petroleum Engineering, Vol. 49, Iss. 5-6, 2013-09 ,pp. : 346-350

Springer Publishing Company

Access to resources Recommend Favorite

Analysis of the power of a rotary-press drive for the molding of multiple-component combined articles

By Arkhangelskii V. Teplishchev S.

Chemical and Petroleum Engineering, Vol. 47, Iss. 3-4, 2011-07 ,pp. : 161-166

Springer Publishing Company

Access to resources Recommend Favorite

Erratum: To the article “Method for Molding Fibreglass Objects Based on Polymer Binder Electrophysical Treatment”

By Erenkov O. Ivakhnenko A. Radchenko M.

Chemical and Petroleum Engineering, Vol. 49, Iss. 7-8, 2013-11 ,pp. : 564-564

Springer Publishing Company

Access to resources Recommend Favorite