Period of time: 2012年1期
Publisher: Edp Sciences
Founded in: 2010
Total resources: 24
E-ISSN: 2107-6847|3|1
ISSN: 2107-6839
Subject: X Environmental Science, Safety Science
Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.
International Journal of Metrology and Quality Engineering,volume 3,issue 1
Menu
The influence of geometrical tolerances of Vickers indenter on the accuracy of measured hardness
By El-Sherbiny M.,Hegazy R.,Ibrahim M.,Abuelezz A. in (2012)
International Journal of Metrology and Quality Engineering,volume 3,issue 1 , Vol. 3, Iss. 1, 2012-09 , pp.By Loisel J.-P.,Topsu S.,Chassagne L.,Alayli Y.,Dahoo P.R.,Juncar P. in (2012)
International Journal of Metrology and Quality Engineering,volume 3,issue 1 , Vol. 3, Iss. 1, 2012-09 , pp.By Fank S.,Aydemir B. in (2012)
International Journal of Metrology and Quality Engineering,volume 3,issue 1 , Vol. 3, Iss. 1, 2012-09 , pp.By Zivkovic V.,Zelenika S.,Stefanovic G. in (2012)
International Journal of Metrology and Quality Engineering,volume 3,issue 1 , Vol. 3, Iss. 1, 2012-09 , pp.Importance and estimation of mismatch uncertainty for RF parameters in calibration laboratories
By Patel K.,Negi P.S. in (2012)
International Journal of Metrology and Quality Engineering,volume 3,issue 1 , Vol. 3, Iss. 1, 2012-09 , pp.By Mandavgade N.K.,Jaju S.B.,Lakhe R.R. in (2012)
International Journal of Metrology and Quality Engineering,volume 3,issue 1 , Vol. 3, Iss. 1, 2012-09 , pp.Control of involute curve of gear tooth using the fuzzy logic
By Bloul B.,Bourdim A. in (2012)
International Journal of Metrology and Quality Engineering,volume 3,issue 1 , Vol. 3, Iss. 1, 2012-09 , pp.Evaluation of metrology technologies for free form surfaces
By Arámbula K.,Siller H.R.,De Chiffre L.,Rodríguez C.A.,Cantatore A. in (2012)
International Journal of Metrology and Quality Engineering,volume 3,issue 1 , Vol. 3, Iss. 1, 2012-09 , pp.