Period of time: 2013年2期
Publisher: Inderscience Publishers
Founded in: 2006
Total resources: 35
ISSN: 1748-5711
Subject: T Industrial Technology
Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.
International Journal of Machining and Machinability of Materials,volume 1,issue 2
Menu
On simulation of magnetic abrasive finishing process for plane surfaces using FEM
By Madhab G.B.,Jain V.K.,Dixit P.M. in (2006)
International Journal of Machining and Machinability of Materials,volume 1,issue 2 , Vol. 1, Iss. 2, 2006-10 , pp.Modelling cutting forces in milling on torus cutters
By Gilles Patrick,Monies Frederic,Rubio Walter in (2006)
International Journal of Machining and Machinability of Materials,volume 1,issue 2 , Vol. 1, Iss. 2, 2006-10 , pp.Recent research on the machining of wood-based composite materials
By Philbin Paul,Gordon Seamus in (2006)
International Journal of Machining and Machinability of Materials,volume 1,issue 2 , Vol. 1, Iss. 2, 2006-10 , pp.The microstructure of ultra-fine grade Ti (C, N)-based cermets
By Liu Ning,Chao Sheng in (2006)
International Journal of Machining and Machinability of Materials,volume 1,issue 2 , Vol. 1, Iss. 2, 2006-10 , pp.By Palanisamy P.,Rajendran I.,Shanmugasundaram S. in (2006)
International Journal of Machining and Machinability of Materials,volume 1,issue 2 , Vol. 1, Iss. 2, 2006-10 , pp.Chip analysis for the determination of flank wear in dry turning
By Haq A. Noorul,Tamizharasan T. in (2006)
International Journal of Machining and Machinability of Materials,volume 1,issue 2 , Vol. 1, Iss. 2, 2006-10 , pp.