Machining Science and Technology,volume 15,issue 1  (01-2014)

Period of time： 2014年1期

Publisher： Taylor & Francis Ltd

Founded in： 1997

Total resources： 31

ISSN： 1091-0344

Subject： TH Machinery and Instrument Industry

Favorite

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Machining Science and Technology,volume 15,issue 1

Menu

DYNAMIC PROPERTIES FOR MODELING AND SIMULATION OF MACHINING: EFFECT OF PEARLITE TO AUSTENITE PHASE TRANSITION ON FLOW STRESS IN AISI 1075 STEEL

By Burns Timothy in (2011)

Machining Science and Technology,volume 15,issue 1 , Vol. 15, Iss. 1, 2011-01 , pp. 1-20

Taylor & Francis Ltd

Abstract Access to resources Recommend Favorite

3D FINITE ELEMENT MODELLING OF CHIP FORMATION PROCESS FOR MACHINING INCONEL 718: COMPARISON OF FE SOFTWARE PREDICTIONS

By Ozel T. in (2011)

Machining Science and Technology,volume 15,issue 1 , Vol. 15, Iss. 1, 2011-01 , pp. 21-46

Taylor & Francis Ltd

Abstract Access to resources Recommend Favorite

PARAMETRIC INFLUENCE AND OPTIMIZATION OF WIRE EDM OF HOT DIE STEEL

By Kuruvila Nixon in (2011)

Machining Science and Technology,volume 15,issue 1 , Vol. 15, Iss. 1, 2011-01 , pp. 47-75

Taylor & Francis Ltd

Abstract Access to resources Recommend Favorite

AN ANALYSIS OF SURFACE INTEGRITY WHEN DRILLING INCONEL 718 USING PALM OIL AND SYNTHETIC ESTER UNDER MQL CONDITION

By Rahim Erween in (2011)

Machining Science and Technology,volume 15,issue 1 , Vol. 15, Iss. 1, 2011-01 , pp. 76-90

Taylor & Francis Ltd

Abstract Access to resources Recommend Favorite

OPTIMIZATION OF CUTTING CONDITIONS IN DRILLING OPERATIONS WITH PLANE RAKE FACED TWIST DRILLS

By Wang Jun,Zhang Qiang,Mathew Philip in (2011)

Machining Science and Technology,volume 15,issue 1 , Vol. 15, Iss. 1, 2011-01 , pp. 91-109

Taylor & Francis Ltd

Abstract Access to resources Recommend Favorite

ANALYSIS OF CUTTING CHARACTERISTIC OF POLYCARBONATE SHEET SUBJECTED TO WEDGE INDENTATION BY KNIFE EDGE AND GROOVED PLATE

By Nagasawa Shigeru,Masaki Yuuya,Fujikura Masatoshi,Lukkanasirikul Nopparat,Fukuzawa Yasushi in (2011)

Machining Science and Technology,volume 15,issue 1 , Vol. 15, Iss. 1, 2011-01 , pp. 110-131

Taylor & Francis Ltd

Abstract Access to resources Recommend Favorite

MECHANISM OF CHIP FORMATION IN HIGH-SPEED TURNING OF INCONEL 718

By Pawade R. S.,Joshi Suhas in (2011)

Machining Science and Technology,volume 15,issue 1 , Vol. 15, Iss. 1, 2011-01 , pp. 132-152

Taylor & Francis Ltd

Abstract Access to resources Recommend Favorite

Total 7 item(s)