Cutting tool reliability analysis for variable feed milling of 17-4PH stainless steel

Author： Klim Z.   Balazinski M.   Ennajimi E.   Fortin C.  

Publisher： Elsevier

ISSN： 0043-1648

Source： Wear, Vol.195, Iss.1, 1996-07, pp. : 206-213

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Effect of Variable Pitch on Cutting Temperature, Cutting Forces and Surface Roughness Using Nitico30 Cutting Tool when End Milling of Stainless Steel 316L

By  

Materials Science Forum, Vol. 2017, Iss. 909, 2017-12 ,pp. : 50-55

Trans Tech Publications

Access to resources Recommend Favorite

Investigation into the relationship between tool-wear and cutting environments when milling an austenitic stainless steel and En32 low carbon steel

By Stanford M   Lister P.M.  

Industrial Lubrication and Tribology, Vol. 57, Iss. 2, 2005-02 ,pp. : 73-79

Emerald Group Publishing Ltd

Access to resources Recommend Favorite

Cutting fluid efficiency in end milling of AISI 304 stainless steel

By Abou-El-Hossein K.A.  

Industrial Lubrication and Tribology, Vol. 60, Iss. 3, 2008-05 ,pp. : 115-120

Emerald Group Publishing Ltd

Access to resources Recommend Favorite

Effect of Post Weld Heat Treatment on Mechanical Properties of 17-4-PH Stainless Steel Welds

By  

Materials Science Forum, Vol. 2015, Iss. 830, 2015-10 ,pp. : 181-184

Trans Tech Publications

Access to resources Recommend Favorite

Thermal Aging Effect of 17-4PH Martensitic Stainless Steel Valves for Nuclear Power Plant

By  

Materials Science Forum, Vol. 2016, Iss. 850, 2016-04 ,pp. : 96-100

Trans Tech Publications

Access to resources Recommend Favorite