Effect of Variable Pitch on Cutting Temperature, Cutting Forces and Surface Roughness Using Nitico30 Cutting Tool when End Milling of Stainless Steel 316L

Publisher： Trans Tech Publications

E-ISSN： 1662-9752|2017|909|50-55

ISSN： 0255-5476

Source： Materials Science Forum, Vol.2017, Iss.909, 2017-12, pp. : 50-55

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

The Cutting Speed Influences on Tool Wear of ZTA Ceramic Cutting Tools and Surface Roughness of Work Material Stainless Steel 316L during High Speed Machining

By  

Materials Science Forum, Vol. 2016, Iss. 840, 2016-02 ,pp. : 315-320

Trans Tech Publications

Access to resources Recommend Favorite

The Effect of Cutting Speed and Feed Rate on Surface Roughness and Tool Wear when Machining Machining D2 Steel

By  

Materials Science Forum, Vol. 2017, Iss. 909, 2017-12 ,pp. : 80-85

Trans Tech Publications

Access to resources Recommend Favorite

Cutting tool reliability analysis for variable feed milling of 17-4PH stainless steel

By Klim Z.   Balazinski M.   Ennajimi E.   Fortin C.  

Wear, Vol. 195, Iss. 1, 1996-07 ,pp. : 206-213

Elsevier

Access to resources Recommend Favorite

Cutting Temperature and Cutting Forces Investigation Based on the Taguchi Design Method when High-Speed Milling of Titanium Matrix Composites with PCD Tool

By  

Materials Science Forum, Vol. 2016, Iss. 836, 2016-02 ,pp. : 168-174

Trans Tech Publications

Access to resources Recommend Favorite

Cutting fluid efficiency in end milling of AISI 304 stainless steel

By Abou-El-Hossein K.A.  

Industrial Lubrication and Tribology, Vol. 60, Iss. 3, 2008-05 ,pp. : 115-120

Emerald Group Publishing Ltd

Access to resources Recommend Favorite