Temperature and wear of cutting tools in high-speed machining of Inconel 718 and Ti-6Al-6V-2Sn

Author： Maekawa K.   Kitagawa T.   Kubo A.  

Publisher： Elsevier

ISSN： 0043-1648

Source： Wear, Vol.202, Iss.2, 1997-01, pp. : 142-148

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Effects of Cutting Atmosphere on High-Speed End Milling Process for Titanium Alloy Ti6Al4V

By  

Materials Science Forum, Vol. 2016, Iss. 874, 2016-11 ,pp. : 46-51

Trans Tech Publications

Access to resources Recommend Favorite

Investigation of Temperature and Stress Distribution on High Speed Machining of Ti6Al4V and 316L Steel Biomaterials Using Explicit Dynamic Analysis

By  

Materials Science Forum, Vol. 2017, Iss. 889, 2017-04 ,pp. : 84-89

Trans Tech Publications

Access to resources Recommend Favorite

Finite Element Simulation of High Speed Machining of Ti6Al4V Alloy and the Corresponding Experimental Study

By  

Materials Science Forum, Vol. 2016, Iss. 836, 2016-02 ,pp. : 444-451

Trans Tech Publications

Access to resources Recommend Favorite

Wear mechanisms of cutting tools in high-speed cutting processes

By Dolinsek S.   Sustarsic B.   Kopac J.  

Wear, Vol. 250, Iss. 1, 2001-10 ,pp. : 349-356

Elsevier

Access to resources Recommend Favorite

Linear Friction Welding of IN718 to Ti6Al4V

By  

Materials Science Forum, Vol. 2016, Iss. 879, 2017-02 ,pp. : 2072-2077

Trans Tech Publications

Access to resources Recommend Favorite