Investigation of Temperature and Stress Distribution on High Speed Machining of Ti6Al4V and 316L Steel Biomaterials Using Explicit Dynamic Analysis

Publisher： Trans Tech Publications

E-ISSN： 1662-9752|2017|889|84-89

ISSN： 0255-5476

Source： Materials Science Forum, Vol.2017, Iss.889, 2017-04, pp. : 84-89

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Temperature and wear of cutting tools in high-speed machining of Inconel 718 and Ti-6Al-6V-2Sn

By Maekawa K.   Kitagawa T.   Kubo A.  

Wear, Vol. 202, Iss. 2, 1997-01 ,pp. : 142-148

Elsevier

Access to resources Recommend Favorite

Finite Element Simulation of High Speed Machining of Ti6Al4V Alloy and the Corresponding Experimental Study

By  

Materials Science Forum, Vol. 2016, Iss. 836, 2016-02 ,pp. : 444-451

Trans Tech Publications

Access to resources Recommend Favorite

Determining a Flow Stress Model for High Temperature Deformation of Ti-6Al-4V

By  

Materials Science Forum, Vol. 2015, Iss. 828, 2015-09 ,pp. : 441-446

Trans Tech Publications

Access to resources Recommend Favorite

Analysis of Heat Generated in the Shear Zone during Machining of Titanium Alloy Ti6Al4V Using Infrared Thermal Camera

By  

Materials Science Forum, Vol. 2018, Iss. 911, 2018-02 ,pp. : 3-7

Trans Tech Publications

Access to resources Recommend Favorite

Effects of Cutting Atmosphere on High-Speed End Milling Process for Titanium Alloy Ti6Al4V

By  

Materials Science Forum, Vol. 2016, Iss. 874, 2016-11 ,pp. : 46-51

Trans Tech Publications

Access to resources Recommend Favorite