The Influence of the Measuring/Viewing Angle on the Color of Injection-Molded Plastics

Author： Arino Ingrid Boldizar Antal Ignell Sofie Karlsson Hanna Kleist Ulf Rebeggiani Sabina Rigdahl Mikael

ISSN： 0091-4037

Source： International Journal of Polymeric Materials, Vol.59, Iss.4, 2010-04, pp. : 292-306

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Metal–Plastic Adhesion in Injection-Molded Hybrids

By Honkanen Mari

Journal of Adhesion Science and Technology, Vol. 23, Iss. 13-14, 2009-09 ,pp. : 1747-1761

Taylor & Francis Ltd

Access to resources Recommend Favorite

Development and Characterization of the Injection-Molded Polymer Composites Made from Bicomponent Fibers

Polymer-Plastics Technology and Engineering, Vol. 54, Iss. 1, 2015-01 ,pp. : 33-46

Taylor & Francis Ltd

Access to resources Recommend Favorite

Investigation of Selected Properties of Injection-Molded Parts Subjected to Natural Aging

By Jachowicz Tomasz Garbacz Tomasz Tor-Świątek Aneta Gajdoš Ivan Czulak Andrzej

International Journal of Polymer Analysis and Characterization, Vol. 20, Iss. 4, 2015-05 ,pp. : 307-315

Taylor & Francis Ltd

Access to resources Recommend Favorite

Injection-Compression Molded Part Shrinkage Uniformity Comparison between Semicrystalline and Amorphous Plastics

By Huang Han-Xiong Li Kun Li Sha

Polymer-Plastics Technology and Engineering, Vol. 48, Iss. 1, 2009-01 ,pp. : 64-68

Taylor & Francis Ltd

Access to resources Recommend Favorite

Injection-molded plastic plate with hydrophobic surface by nanoperiodic structure applied in uniaxial direction

Journal of Adhesion Science and Technology, Vol. 29, Iss. 1, 2015-01 ,pp. : 24-35

Taylor & Francis Ltd

Access to resources Recommend Favorite