![](/images/ico/ico_close.png)
![](/images/ico/ico5.png)
Author: Jianhua Liu Jianxin Deng Jinlong Zhao
Publisher: Inderscience Publishers
ISSN: 1748-5711
Source: International Journal of Machining and Machinability of Materials, Vol.1, Iss.3, 2006-11, pp. : 324-332
Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.
Abstract
Related content
![](/images/ico/ico_close.png)
![](/images/ico/ico5.png)
By Grzesik Wit
International Journal of Machining and Machinability of Materials, Vol. 4, Iss. 1, 2008-10 ,pp. :
![](/images/ico/ico_close.png)
![](/images/ico/ico5.png)
Crater wear mechanisms of tin coated high speed steel tools
By Lim C.Y.H. Lim S.C. Lee K.S.
Surface Engineering, Vol. 16, Iss. 3, 2000-06 ,pp. :
![](/images/ico/ico_close.png)
![](/images/ico/ico5.png)
By Kumar CH.R. Vikram Nair P. Kesavan Ramamoorthy B.
International Journal of Machining and Machinability of Materials, Vol. 3, Iss. 1-2, 2008-03 ,pp. :
![](/images/ico/ico_close.png)
![](/images/ico/ico5.png)
WEAR MECHANISMS WHEN MACHINING GREY CAST IRON WITH CERAMIC TOOLS
By Brandt G. Mikus M. Senesan Z. Hogmark S.
Surface Engineering, Vol. 3, Iss. 3, 1987-01 ,pp. :
![](/images/ico/ico_close.png)
![](/images/ico/ico5.png)
By Zemzemi F. Rech J. Salem W. Ben Dogui A. Kapsa P.
International Journal of Machining and Machinability of Materials, Vol. 2, Iss. 3-4, 2007-10 ,pp. :