Investigating wear mechanisms of CBN and mixed-ceramic tools during finish hard turning of low-medium hardness AISI H11 steel

By Dureja J.S.   Gupta V.K.   Sharma Vishal S.   Dogra Manu  

International Journal of Machining and Machinability of Materials, Vol. 10, Iss. 1-2, 2011-06 ,pp. : 120-136

Inderscience Publishers

Access to resources Recommend Favorite

Influence of the Cutting Parameters on the Surface Roughness when Machining Hardened Steel with Ceramic and PCBN Cutting Tools

By  

Advanced Engineering Forum, Vol. 2015, Iss. 13, 2015-08 ,pp. : 19-22

Trans Tech Publications

Access to resources Recommend Favorite

Wear patterns and mechanisms of ZrN coated tools in machining of hardened steel

By Jianhua Liu   Jianxin Deng   Jinlong Zhao  

International Journal of Machining and Machinability of Materials, Vol. 1, Iss. 3, 2006-11 ,pp. : 324-332

Inderscience Publishers

Access to resources Recommend Favorite

Experimental and theoretical investigation of AISI D2 hardened steel machining with varying nose radius CBN tools

By Lee T.H.   Mathew Philip  

International Journal of Machining and Machinability of Materials, Vol. 2, Iss. 2, 2007-05 ,pp. : 254-269

Inderscience Publishers

Access to resources Recommend Favorite

Investigation of the surface integrity induced by abrasive flow machining on AISI D2 hardened steel

By Kenda J.   Kermouche G.   Dumont F.   Rech J.   Kopac J.  

International Journal of Materials and Product Technology, Vol. 46, Iss. 1, 2013-03 ,pp. : 19-31

Inderscience Publishers

Access to resources Recommend Favorite