Machined surface image analysis when turning with modified cutting points

By Zawada-Tomkiewicz Anna   Storch Borys  

International Journal of Machining and Machinability of Materials, Vol. 5, Iss. 2-3, 2009-02 ,pp. : 278-289

Inderscience Publishers

Access to resources Recommend Favorite

Modelling, optimisation and experimental validation of cutting parameters to achieve minimum tool wear and surface roughness in hard turning of AISI H11 tool steel

By Saini Sanjeev  

International Journal of Materials Engineering Innovation, Vol. 3, Iss. 3-4, 2012-09 ,pp. : 295-315

Inderscience Publishers

Access to resources Recommend Favorite

Finite element optimization of diamond tool geometry and cutting-process parameters based on surface residual stresses

By Zong W.   Li D.   Cheng K.   Sun T.   Liang Y.  

The International Journal of Advanced Manufacturing Technology, Vol. 32, Iss. 7-8, 2007-04 ,pp. : 666-674

Springer Publishing Company

Access to resources Recommend Favorite

Analysis and optimisation of cutting parameters for surface roughness in machining Al/SiC particulate composites by PCD tool

By Palanikumar K.   Shanmugam K.   Davim J. Paulo  

International Journal of Materials and Product Technology, Vol. 37, Iss. 1-2, 2009-11 ,pp. : 117-128

Inderscience Publishers

Access to resources Recommend Favorite

Solidification microstructure of electrodischarge machined surfaces of tool steels

By Lim L. C.   Lee L. C.   Wong Y. S.   Lu H. H.  

Materials Science and Technology, Vol. 7, Iss. 3, 1991-03 ,pp. : 239-248

Maney Publishing

Access to resources Recommend Favorite