Finite element optimization of diamond tool geometry and cutting-process parameters based on surface residual stresses

Author： Zong W. Li D. Cheng K. Sun T. Liang Y.

ISSN： 0268-3768

Source： The International Journal of Advanced Manufacturing Technology, Vol.32, Iss.7-8, 2007-04, pp. : 666-674

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Related content

Influence of cutting tool constitutive parameters on residual stresses induced by hard turning

By Rech Joel Claudin Christophe

International Journal of Machining and Machinability of Materials, Vol. 4, Iss. 1, 2008-10 ,pp. : 39-50

Inderscience Publishers

Access to resources Recommend Favorite

Pre-evaluation on surface profile in turning process based on cutting parameters

By Lu Chen Ma Ning Chen Zhuo Costes Jean-Philippe

The International Journal of Advanced Manufacturing Technology, Vol. 49, Iss. 5-8, 2010-07 ,pp. : 447-458

Springer Publishing Company

Access to resources Recommend Favorite

Optimization of turning parameters for surface roughness and tool life based on the Taguchi method

By Hasçalık Ahmet Çaydaş Ulaş

The International Journal of Advanced Manufacturing Technology, Vol. 38, Iss. 9-10, 2008-09 ,pp. : 896-903

Springer Publishing Company

Access to resources Recommend Favorite

Residual stresses in chains: Comparison of neutron diffraction and finite element results

By Abolfathi E. Webster P. J. Swallowe G. M. Modlen G. F. Ascough J. Low K. S.

Materials Science and Technology, Vol. 6, Iss. 6, 1990-06 ,pp. : 575-578

Maney Publishing

Access to resources Recommend Favorite

Finite element simulation of welding residual stresses in martensitic steel pipes

By Yaghi A H

Materials Research Innovations, Vol. 17, Iss. 5, 2013-10 ,pp. : 306-311

Maney Publishing

Access to resources Recommend Favorite