Optimisation of finishing conditions in Centrifugal Force Assisted Abrasive Flow Machining using Taguchi method

ISSN： 1368-2148

Source： International Journal of Manufacturing Technology and Management, Vol.18, Iss.1, 2009-04, pp. : 79-93

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Optimum selection of abrasive flow machining conditions during fine finishing of Al/15 wt% SiC-MMC using Taguchi method

By Mali Harlal Manna Alakesh

The International Journal of Advanced Manufacturing Technology, Vol. 50, Iss. 9-12, 2010-10 ,pp. : 1013-1024

Springer Publishing Company

Access to resources Recommend Favorite

Determining dynamically active abrasive particles in the media used in centrifugal force assisted abrasive flow machining process

By Walia R. Shan H. Kumar P.

The International Journal of Advanced Manufacturing Technology, Vol. 38, Iss. 11-12, 2008-10 ,pp. : 1157-1164

Springer Publishing Company

Access to resources Recommend Favorite

Force behaviour in abrasive flow machining

By Mahdy M. Abdel Mohsen

International Journal of Materials and Product Technology, Vol. 17, Iss. 7, 2003-07 ,pp. : 618-642

Inderscience Publishers

Access to resources Recommend Favorite

Study of magnetic abrasive finishing in free-form surface operations using the Taguchi method

By Lin Ching-Tien Yang Lieh-Dai Chow Han-Ming

The International Journal of Advanced Manufacturing Technology, Vol. 34, Iss. 1-2, 2007-08 ,pp. : 122-130

Springer Publishing Company

Access to resources Recommend Favorite

Finishing effect of abrasive flow machining on micro slit fabricated by wire-EDM

By Tzeng Hsinn-Jyh Yan Biing-Hwa Hsu Rong-Tzong Chow Han-Ming

The International Journal of Advanced Manufacturing Technology, Vol. 34, Iss. 7-8, 2007-10 ,pp. : 649-656

Springer Publishing Company

Access to resources Recommend Favorite