Related content

Optimisation of finishing conditions in Centrifugal Force Assisted Abrasive Flow Machining using Taguchi method

By Walia R.S.   Shan H.S.   Kumar P.  

International Journal of Manufacturing Technology and Management, Vol. 18, Iss. 1, 2009-04 ,pp. : 79-93

Inderscience Publishers

Access to resources Recommend Favorite

Taguchi method based optimization of cutting tool flank wear during turning of PR-Al/20vol.% SiC-MMC

By Manna Alakesh   Bhattacharyya Bijay  

International Journal of Machining and Machinability of Materials, Vol. 1, Iss. 4, 2007-02 ,pp. : 488-499

Inderscience Publishers

Access to resources Recommend Favorite

Multi-response optimisation of machining parameters during drilling LM6Mg15SiC-Al-MMC based on Grey relational analysis

By Manna Alakesh  

International Journal of Machining and Machinability of Materials, Vol. 14, Iss. 3, 2013-09 ,pp. : 275-294

Inderscience Publishers

Access to resources Recommend Favorite

Multi response optimization of machining parameters of drilling Al/SiC metal matrix composite using grey relational analysis in the Taguchi method

By Haq A.   Marimuthu P.   Jeyapaul R.  

The International Journal of Advanced Manufacturing Technology, Vol. 37, Iss. 3-4, 2008-05 ,pp. : 250-255

Springer Publishing Company

Access to resources Recommend Favorite

Microstructure and mechanical properties of Al-4.5 wt-%Cu/15 wt-%SiC composite prepared using ball mill

By Lu L.   Lai M. O.   Yap S. H.  

Materials Science and Technology, Vol. 13, Iss. 3, 1997-03 ,pp. : 192-202

Maney Publishing

Access to resources Recommend Favorite