Evolution of EDM process modelling and development towards modelling of the micro-EDM process

Author： Dhanik Sandeep   Joshi S.S.   Ramakrishnan N.   Apte P.R.  

Publisher： Inderscience Publishers

ISSN： 1368-2148

Source： International Journal of Manufacturing Technology and Management, Vol.7, Iss.2-3, 2005-04, pp. : 157-180

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Process planning and electrode wear compensation for 3D micro-EDM

By Yan Mu-Tian   Lin Shr-Shiang  

The International Journal of Advanced Manufacturing Technology, Vol. 53, Iss. 1-4, 2011-03 ,pp. : 209-219

Springer Publishing Company

Access to resources Recommend Favorite

Mapping the material removal behaviour of micro deep hole drilling EDM process

By Balasubramaniam R.  

International Journal of Mechatronics and Manufacturing Systems, Vol. 5, Iss. 5-6, 2012-10 ,pp. : 516-527

Inderscience Publishers

Access to resources Recommend Favorite

Assessment of the dynamical properties in EDM process—detecting deterministic nonlinearity of EDM process

By Zhou Ming   Han Fuzhu   Wang Yongxain   Soichiro Isago  

The International Journal of Advanced Manufacturing Technology, Vol. 44, Iss. 1-2, 2009-09 ,pp. : 91-99

Springer Publishing Company

Access to resources Recommend Favorite

A review on various research trends in micro-EDM

By Kadirvel A.  

International Journal of Mechatronics and Manufacturing Systems, Vol. 5, Iss. 5-6, 2012-10 ,pp. : 361-384

Inderscience Publishers

Access to resources Recommend Favorite

A method for microstructures fabrication by using micro-EDM

By Zhang Yong   Wang Zhenlong   Li Zhiyong   Zhao Wansheng  

International Journal of Machining and Machinability of Materials, Vol. 2, Iss. 1, 2007-03 ,pp. : 59-70

Inderscience Publishers

Access to resources Recommend Favorite