Residual stress measurements in rolling mill rolls using deep hole drilling technique

ISSN： 1743-2812

Source： Ironmaking & Steelmaking, Vol.32, Iss.5, 2005-10, pp. : 379-380

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Calibration of residual stress measurements obtained from EDM hole drilling method using physical material properties

By Lee H. T. Liu C.

Materials Science and Technology, Vol. 24, Iss. 12, 2008-12 ,pp. : 1462-1469

Maney Publishing

Access to resources Recommend Favorite

Feasibility evaluation of EDM hole drilling method for residual stress measurement

By Lee H. T. Hsu F. C.

Materials Science and Technology, Vol. 19, Iss. 9, 2003-09 ,pp. : 1261-1265

Maney Publishing

Access to resources Recommend Favorite

Measurement of residual stresses in vvelded steel joints using hole drilling method

By Weng C. C. Lo S. C.

Materials Science and Technology, Vol. 8, Iss. 3, 1992-03 ,pp. : 212-218

Maney Publishing

Access to resources Recommend Favorite

Error induced by local yielding around hole in hole drilling method for measuring residual stress of materials

By Lin Y. C Chou C. P.

Materials Science and Technology, Vol. 11, Iss. 6, 1995-06 ,pp. : 600-604

Maney Publishing

Access to resources Recommend Favorite

Varying bending eigenfrequencies in BTA deep hole drilling: mechanical modeling using statistical parameter estimation

By Weinert Klaus

Production Engineering, Vol. 1, Iss. 2, 2007-10 ,pp. : 127-134

Springer Publishing Company

Access to resources Recommend Favorite