Error induced by local yielding around hole in hole drilling method for measuring residual stress of materials

ISSN： 1743-2847

Source： Materials Science and Technology, Vol.11, Iss.6, 1995-06, pp. : 600-604

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Feasibility evaluation of EDM hole drilling method for residual stress measurement

By Lee H. T. Hsu F. C.

Materials Science and Technology, Vol. 19, Iss. 9, 2003-09 ,pp. : 1261-1265

Maney Publishing

Access to resources Recommend Favorite

Calibration of residual stress measurements obtained from EDM hole drilling method using physical material properties

By Lee H. T. Liu C.

Materials Science and Technology, Vol. 24, Iss. 12, 2008-12 ,pp. : 1462-1469

Maney Publishing

Access to resources Recommend Favorite

Measurement of residual stresses in vvelded steel joints using hole drilling method

By Weng C. C. Lo S. C.

Materials Science and Technology, Vol. 8, Iss. 3, 1992-03 ,pp. : 212-218

Maney Publishing

Access to resources Recommend Favorite

Residual stress measurements in rolling mill rolls using deep hole drilling technique

By Kingston E. Smith D. J.

Ironmaking & Steelmaking, Vol. 32, Iss. 5, 2005-10 ,pp. : 379-380

Maney Publishing

Access to resources Recommend Favorite

Determining optimum EDM parameters in drilling a small hole by Taguchi method

By Yusoff Ahmad Razlan Ghazalli Zakri Hussain Hazami Che

International Journal of Manufacturing Technology and Management, Vol. 17, Iss. 4, 2009-03 ,pp. : 345-352

Inderscience Publishers

Access to resources Recommend Favorite