Creep behaviour of AZ61 magnesium alloy at low stresses and intermediate temperatures

Author： Srivastava V. McNee K. R. Greenwood G. W. Jones H.

ISSN： 1743-2847

Source： Materials Science and Technology, Vol.20, Iss.1, 2004-01, pp. : 42-46

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Tensile creep response was investigated for AZ61 alloy (Mg - 6^.4Al - 0^.9Zn - 0^.2Mn, wt-%) of mean linear intercept grain size ~ 25 μm at stresses in the range 0.9 - 4 MPa over the temperature range 250 - 346°C. Bingham behaviour is obtained with strain rate ε under stress σ given by ε∝σ - σ_o with a threshold stress σ_o decreasing from 1.25 MPa at 210°C to ~ 0.5 MPa at 346°C, which is similar to earlier work on pure magnesium. The corresponding Arrhenius plot of log (Tdε/d σ) versus T^-1 indicates an activation energy comparable with that expected for the grain boundary self-diffusion coefficient D_B, and values of D_Bδ (where δ is the effective grain boundary thickness) derived from the Coble equation are also similar to those for pure magnesium. Grain elongation in the direction of the tensile stress is also consistent with the key indicative feature of diffusional creep: deposition of material at grain boundaries nearly transverse to the axis of tensile stressing. Strain rates versus stress are shown to be continuous with published results for superplastic flow of AZ61 at comparable temperatures but higher stresses.