Physically based dynamic model for control of cavity pressure in injection moulding of amorphous plastics

Author： Rafizadeh M.   Patterson W.I.   Kamal M.R.  

Publisher： Maney Publishing

ISSN： 1743-2898

Source： Plastics, Rubber and Composites, Vol.28, Iss.2, 1999-02, pp. : 47-61

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Cavity Pressure Response and Melt Flow Length During Dynamic Injection Molding

By Hong-wu Wu   hai-hang Xu   Jin-ping Qu   Shao-dan Zhang  

Polymer-Plastics Technology and Engineering, Vol. 45, Iss. 8, 2006-01 ,pp. : 935-937

Taylor & Francis Ltd

Access to resources Recommend Favorite

Precision control of high speed injection moulding machines

By Yamanaka K.   Nishimura K.   Uchiyama T.   Irube K.  

Plastics, Rubber and Composites, Vol. 34, Iss. 5-6, 2005-06 ,pp. : 259-264

Maney Publishing

Access to resources Recommend Favorite

Effect of cavity pressure on crosslink density of injection moulded silicone rubber

By Barbaroux M.   Régnier G.   Verdu J.  

Plastics, Rubber and Composites, Vol. 29, Iss. 5, 2000-05 ,pp. : 229-234

Maney Publishing

Access to resources Recommend Favorite

Measurement and Analysis of Cavity Pressure and Melt Filling Capacity During Injection Molding

By Hong-wu Wu   Shao-dan Zhang   Jin-ping Qu   Hai-hang Xu  

Polymer-Plastics Technology and Engineering, Vol. 46, Iss. 2, 2007-02 ,pp. : 123-127

Taylor & Francis Ltd

Access to resources Recommend Favorite

Injection-Compression Molded Part Shrinkage Uniformity Comparison between Semicrystalline and Amorphous Plastics

By Huang Han-Xiong   Li Kun   Li Sha  

Polymer-Plastics Technology and Engineering, Vol. 48, Iss. 1, 2009-01 ,pp. : 64-68

Taylor & Francis Ltd

Access to resources Recommend Favorite