Enhancement of surface replication by gas assisted microinjection moulding

By Yoon S.-H.   Lee K.-H.   Palanisamy P.   Lee J. S.   Cha N.-G.   Carter D. J.   Mead J. L.   Barry C. M. F.  

Plastics, Rubber and Composites, Vol. 39, Iss. 7, 2010-09 ,pp. : 293-299

Maney Publishing

Access to resources Recommend Favorite

Two-component microinjection moulding for MID fabrication

By Islam A.   Hansen H. N.   Tang P. T.   Jørgensen M. B.   Ørts S. F.  

Plastics, Rubber and Composites, Vol. 39, Iss. 7, 2010-09 ,pp. : 300-307

Maney Publishing

Access to resources Recommend Favorite

Comparison of height replication properties of micro-injection moulding and micro-injection–compression moulding for production of microstructures on lightguiding plates

By Shen Y. K.  

Plastics, Rubber and Composites, Vol. 36, Iss. 2, 2007-03 ,pp. : 77-84

Maney Publishing

Access to resources Recommend Favorite

Morphology of microinjection moulded polyoxymethylene

By Kamal M. R.   Chu J.   Derdouri S.   Hrymak A.  

Plastics, Rubber and Composites, Vol. 39, Iss. 7, 2010-09 ,pp. : 332-341

Maney Publishing

Access to resources Recommend Favorite

Rotational moulding of metallocene polyethylenes

By Xin W.   Harkin-Jones E.H.   Crawford R.J.   Fatnes A.-M.  

Plastics, Rubber and Composites, Vol. 29, Iss. 7, 2000-07 ,pp. : 340-348

Maney Publishing

Access to resources Recommend Favorite