Comparison of height replication properties of micro-injection moulding and micro-injection–compression moulding for production of microstructures on lightguiding plates

Author： Shen Y. K.  

Publisher： Maney Publishing

ISSN： 1743-2898

Source： Plastics, Rubber and Composites, Vol.36, Iss.2, 2007-03, pp. : 77-84

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Evaluation of replication properties on moulded surface by ultrasonic injection moulding system

By Sato A.   Sakaguchi H.   Ito H.   Koyama K.  

Plastics, Rubber and Composites, Vol. 39, Iss. 7, 2010-09 ,pp. : 315-320

Maney Publishing

Access to resources Recommend Favorite

One- and two-component micro powder injection moulding derived from thermoplastic microreplication

By Piotter V.   Mueller T.   Plewa K.   Ritzhaupt-Kleissl H.-J.   Ruh A.   Hausselt J.  

Plastics, Rubber and Composites, Vol. 39, Iss. 7, 2010-09 ,pp. : 287-292

Maney Publishing

Access to resources Recommend Favorite

Enhancement of surface replication by gas assisted microinjection moulding

By Yoon S.-H.   Lee K.-H.   Palanisamy P.   Lee J. S.   Cha N.-G.   Carter D. J.   Mead J. L.   Barry C. M. F.  

Plastics, Rubber and Composites, Vol. 39, Iss. 7, 2010-09 ,pp. : 293-299

Maney Publishing

Access to resources Recommend Favorite

Mechanical properties of polydicyclopentadiene/graphite nanosheet composites prepared by reaction injection moulding

By Pan B L   Zhang C F   Zhao J   Zhang Y Q   Zhang Y Z  

Plastics, Rubber and Composites, Vol. 41, Iss. 8, 2012-10 ,pp. : 319-325

Maney Publishing

Access to resources Recommend Favorite

Microinjection moulding of polymers

By Coulter John  

Plastics, Rubber and Composites, Vol. 39, Iss. 7, 2010-09 ,pp. : 285-285

Maney Publishing

Access to resources Recommend Favorite