Two-component water assisted injection moulding

By Lang S.   Parkinson M. J.  

Plastics, Rubber and Composites, Vol. 34, Iss. 5-6, 2005-06 ,pp. : 232-235

Maney Publishing

Access to resources Recommend Favorite

Two-component microinjection moulding for MID fabrication

By Islam A.   Hansen H. N.   Tang P. T.   Jørgensen M. B.   Ørts S. F.  

Plastics, Rubber and Composites, Vol. 39, Iss. 7, 2010-09 ,pp. : 300-307

Maney Publishing

Access to resources Recommend Favorite

In mould painting using thermoset powder coating and thermoplastic substrate in closed tool injection moulding

By Goodship V.   Cook N.   Dargue I.   Lobjoit C.   Makenji K.   Smith G. F.  

Plastics, Rubber and Composites, Vol. 36, Iss. 1, 2007-02 ,pp. : 34-41

Maney Publishing

Access to resources Recommend Favorite

Comparison of height replication properties of micro-injection moulding and micro-injection–compression moulding for production of microstructures on lightguiding plates

By Shen Y. K.  

Plastics, Rubber and Composites, Vol. 36, Iss. 2, 2007-03 ,pp. : 77-84

Maney Publishing

Access to resources Recommend Favorite

Gas assisted injection moulding: adding two components and moveable inserts

By Neerincx P. E.   Meijer H. E. H.  

Plastics, Rubber and Composites, Vol. 38, Iss. 9-10, 2009-12 ,pp. : 444-452

Maney Publishing

Access to resources Recommend Favorite