Wear Mechanism and Cutting Performance of Conventional and High-Strength PM High-Speed Steels

ISSN： 1743-2901

Source： Powder Metallurgy, Vol.25, Iss.2, 1982-01, pp. : 79-84

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Relation Between Microstructure and Strength in Conventional and Powder-Processed High-Speed Steels

By Almond E. A. Irani R. S.

Powder Metallurgy, Vol. 24, Iss. 2, 1981-01 ,pp. : 105-113

Maney Publishing

Access to resources Recommend Favorite

Research on the Influence of Tool Wear on Cutting Performance in High-Speed Milling of Difficult-to-Cut Materials

Key Engineering Materials, Vol. 2016, Iss. 693, 2016-06 ,pp. : 1129-1134

Trans Tech Publications

Access to resources Recommend Favorite

Sintering and alloy design for high performance PM steels

Powder Metallurgy, Vol. 47, Iss. 4, 2004-12 ,pp. : 313-314

Maney Publishing

Access to resources Recommend Favorite

Powders and Processes for High Performance PM Steels

By Engström U. Lindberg C. Tengzelius J.

Powder Metallurgy, Vol. 35, Iss. 1, 1992-01 ,pp. : 67-73

Maney Publishing

Access to resources Recommend Favorite

Effect of Chemical Composition and Heat Treatment Parameters on the Structure and Properties of Vanadis 23 and Vanadis 30 PM High-Speed Steels

Solid State Phenomena, Vol. 2017, Iss. 270, 2017-12 ,pp. : 258-264

Trans Tech Publications

Access to resources Recommend Favorite