Research on the Influence of Tool Wear on Cutting Performance in High-Speed Milling of Difficult-to-Cut Materials

Publisher： Trans Tech Publications

E-ISSN： 1662-9795|2016|693|1129-1134

ISSN： 1013-9826

Source： Key Engineering Materials, Vol.2016, Iss.693, 2016-06, pp. : 1129-1134

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Wear of PCBN Tool when Cutting Materials Difficult-to-Cut Based on Thermodynamics Solubility

By  

Key Engineering Materials, Vol. 2016, Iss. 693, 2016-06 ,pp. : 1207-1215

Trans Tech Publications

Access to resources Recommend Favorite

Investigation of Machinability in Milling of Difficult-to-Cut Materials Using Water Soluble and Water Insoluble Cutting Oil

By  

Key Engineering Materials, Vol. 2015, Iss. 656, 2015-08 ,pp. : 308-313

Trans Tech Publications

Access to resources Recommend Favorite

Effects of Supplying Oil Mist and Water Mist with Cold Air on Cutting Force and Temperature in End Milling of Difficult-to-Cut Materials

By  

Key Engineering Materials, Vol. 2015, Iss. 656, 2015-08 ,pp. : 255-260

Trans Tech Publications

Access to resources Recommend Favorite

Machinability Evaluation of Inclined Planetary Motion Milling System for Difficult-to-Cut Materials

By  

Key Engineering Materials, Vol. 2015, Iss. 656, 2015-08 ,pp. : 320-327

Trans Tech Publications

Access to resources Recommend Favorite

Influence of Cutting Data on the Thin Wall Deformation in Milling of Difficult to Cut Materials

By  

Key Engineering Materials, Vol. 2016, Iss. 686, 2016-03 ,pp. : 86-91

Trans Tech Publications

Access to resources Recommend Favorite