Variability of powder characteristics and their effect on dimensional variability of powder injection moulded components

Author： Heaney D.F.   Zauner R.   Binet C.   Cowan K.   Piemme J.  

Publisher： Maney Publishing

ISSN： 1743-2901

Source： Powder Metallurgy, Vol.47, Iss.2, 2004-03, pp. : 144-149

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Variability of feedstock viscosity and its correlation with dimensional variability of green powder injection moulded components

By Zauner R.   Binet C.   Heaney D.F.   Piemme J.  

Powder Metallurgy, Vol. 47, Iss. 2, 2004-03 ,pp. : 150-155

Maney Publishing

Access to resources Recommend Favorite

In situ dimensional change, mass loss and mechanisms for solvent debinding of powder injection moulded components

By Westcot E. J.   Binet Andrandall C.   German M.  

Powder Metallurgy, Vol. 46, Iss. 1, 2003-04 ,pp. : 61-67

Maney Publishing

Access to resources Recommend Favorite

Effect of nickel boride and boron additions on sintering characteristics of injection moulded 316L powder using water soluble binder system

By Bakan H.I.   Heaney D.   German R.M.  

Powder Metallurgy, Vol. 44, Iss. 3, 2001-03 ,pp. : 235-242

Maney Publishing

Access to resources Recommend Favorite

Experimental and numerical analysis on sintering behaviours of injection moulded components in 316L stainless steel powder

By Song J.   Barriere T.   Liu B.   Gelin J. C.   Michel G.  

Powder Metallurgy, Vol. 53, Iss. 4, 2010-12 ,pp. : 295-304

Maney Publishing

Access to resources Recommend Favorite

Tensile Characteristics of Nitrogen Enhanced Powder Injection Moulded 316L Stainless Steel

By Rawers J.   Croydon F.   Krabbe R.   Duttlinger N.  

Powder Metallurgy, Vol. 39, Iss. 2, 1996-01 ,pp. : 125-129

Maney Publishing

Access to resources Recommend Favorite