In situ dimensional change, mass loss and mechanisms for solvent debinding of powder injection moulded components

Author： Westcot E. J.   Binet Andrandall C.   German M.  

Publisher： Maney Publishing

ISSN： 1743-2901

Source： Powder Metallurgy, Vol.46, Iss.1, 2003-04, pp. : 61-67

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Length Change and Deformation of Powder Injection–Molded Compacts during Solvent Debinding

By Hu S.C.   Hwang K.S.  

Metallurgical and Materials Transactions A, Vol. 31, Iss. 5, 2000-05 ,pp. : 1473-1478

Springer Publishing Company

Access to resources Recommend Favorite

Solvent debinding kinetics and sintered properties of injection moulded 316L stainless steel powder

By Eroglu S.   Bakan H. I.  

Powder Metallurgy, Vol. 48, Iss. 4, 2005-12 ,pp. : 329-332

Maney Publishing

Access to resources Recommend Favorite

Variability of powder characteristics and their effect on dimensional variability of powder injection moulded components

By Heaney D.F.   Zauner R.   Binet C.   Cowan K.   Piemme J.  

Powder Metallurgy, Vol. 47, Iss. 2, 2004-03 ,pp. : 144-149

Maney Publishing

Access to resources Recommend Favorite

Transformation of ferrihydrite to hematite: an in situ investigation on the kinetics and mechanisms

By Vu H. P.   Shaw S.   Benning L. G.  

Mineralogical Magazine, Vol. 72, Iss. 1, 2008-02 ,pp. : 217-220

Mineralogical Society

Access to resources Recommend Favorite

Solvent Debinding Behavior of Powder Injection Molded Components Prepared from Powders with Different Particle Sizes

By Hwang K.S.   Shu G.J.   Lee H.J.  

Metallurgical and Materials Transactions A, Vol. 36, Iss. 1, 2005-01 ,pp. : 161-167

Springer Publishing Company

Access to resources Recommend Favorite