PIMSIM: optimisation of powder injection moulding using advanced moulding simulations

ISSN： 1743-2901

Source： Powder Metallurgy, Vol.52, Iss.4, 2009-12, pp. : 279-281

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Focus on Powder Injection Moulding

By Hayward A.

Powder Metallurgy, Vol. 40, Iss. 3, 1997-01 ,pp. : 170-180

Maney Publishing

Access to resources Recommend Favorite

Optimisation of process conditions in powder injection moulding of microsystem components using robust design method Part 2 – Secondary design parameters

By Urval R. Lee S. Atre S. V. Park S.-J. German Randall M.

Powder Metallurgy, Vol. 53, Iss. 1, 2010-03 ,pp. : 71-81

Maney Publishing

Access to resources Recommend Favorite

Optimisation of process conditions in powder injection moulding of microsystem components using a robust design method: part I. primary design parameters

By Urval R. Lee S. Atre S. V. Park S.-J. German R. M.

Powder Metallurgy, Vol. 51, Iss. 2, 2008-06 ,pp. : 133-142

Maney Publishing

Access to resources Recommend Favorite

Optimisation of Injection Moulding Process for Silicon Nitride Components

By Lii D.-F. Huang J.-L. Wu B.-S.

Powder Metallurgy, Vol. 39, Iss. 4, 1996-01 ,pp. : 291-295

Maney Publishing

Access to resources Recommend Favorite

Powder injection moulding and what the designer needs to know

Metal Powder Report, Vol. 58, Iss. 9, 2003-09 ,pp. : 10-11

Elsevier

Access to resources Recommend Favorite