Optimisation of process conditions in powder injection moulding of microsystem components using robust design method Part 2 – Secondary design parameters

Author： Urval R.   Lee S.   Atre S. V.   Park S.-J.   German Randall M.  

Publisher： Maney Publishing

ISSN： 1743-2901

Source： Powder Metallurgy, Vol.53, Iss.1, 2010-03, pp. : 71-81

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Optimisation of process conditions in powder injection moulding of microsystem components using a robust design method: part I. primary design parameters

By Urval R.   Lee S.   Atre S. V.   Park S.-J.   German R. M.  

Powder Metallurgy, Vol. 51, Iss. 2, 2008-06 ,pp. : 133-142

Maney Publishing

Access to resources Recommend Favorite

Optimisation of Injection Moulding Process for Silicon Nitride Components

By Lii D.-F.   Huang J.-L.   Wu B.-S.  

Powder Metallurgy, Vol. 39, Iss. 4, 1996-01 ,pp. : 291-295

Maney Publishing

Access to resources Recommend Favorite

PIMSIM: optimisation of powder injection moulding using advanced moulding simulations

By Jenni Martin   Wilfinger T.  

Powder Metallurgy, Vol. 52, Iss. 4, 2009-12 ,pp. : 279-281

Maney Publishing

Access to resources Recommend Favorite

Process simulation of powder injection moulding: identification of significant parameters during mould filling phase

By Atre S. V.   Park S.-J.   Zauner R.   German Randall M.  

Powder Metallurgy, Vol. 50, Iss. 1, 2007-03 ,pp. : 76-85

Maney Publishing

Access to resources Recommend Favorite

Design guidelines for processing bi-material components via powder-injection molding

By Johnson John   Tan Lye   Suri Pavan   German Randall  

JOM, Vol. 55, Iss. 10, 2003-10 ,pp. : 30-34

Springer Publishing Company

Access to resources Recommend Favorite