Injection moulding of 316L stainless steels reinforced with nanosize alumina particles

ISSN： 1743-2901

Source： Powder Metallurgy, Vol.54, Iss.3, 2011-07, pp. : 360-365

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Jetting in metal injection moulding of 316L stainless steel

By Dvorak P. Barriere T. Gelin J. C.

Powder Metallurgy, Vol. 48, Iss. 3, 2005-09 ,pp. : 254-260

Maney Publishing

Access to resources Recommend Favorite

Investigation of rheological behaviour of 316L stainless steel–3 wt-%TiC powder injection moulding feedstock

By Khakbiz M. Simchi A. Bagheri R.

Powder Metallurgy, Vol. 48, Iss. 2, 2005-06 ,pp. : 144-150

Maney Publishing

Access to resources Recommend Favorite

Modified metal injection moulding process of 316L stainless steel powders using thermosetting binder

By Levenfeld B. Gruzza A. Várez A. Torralba J.M.

Powder Metallurgy, Vol. 43, Iss. 3, 2000-03 ,pp. : 233-237

Maney Publishing

Access to resources Recommend Favorite

Injection Moulding of 316L Stainless Steel Powder Using Novel Binder System

By Anwar M. Y. Messer P. F. Ellis B. Davies H. A.

Powder Metallurgy, Vol. 38, Iss. 2, 1995-01 ,pp. : 113-119

Maney Publishing

Access to resources Recommend Favorite

Mechanical properties of injection moulded 316L stainless steels with (TiC)N additions

By Gülsoy H.Ö.

Powder Metallurgy, Vol. 50, Iss. 3, 2007-09 ,pp. : 271-275

Maney Publishing

Access to resources Recommend Favorite