Microstructure and mechanical properties of injection moulded Nimonic-90 superalloy parts

Author： Özgün Ö   Gülsoy H Ö   Findik F   Yilmaz R  

Publisher： Maney Publishing

ISSN： 1743-2901

Source： Powder Metallurgy, Vol.55, Iss.5, 2012-12, pp. : 405-414

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Impact of Innovative Cooling System on Mechanical Properties of Moulded Parts

By  

Defect and Diffusion Forum, Vol. 2016, Iss. 368, 2016-08 ,pp. : 49-52

Trans Tech Publications

Access to resources Recommend Favorite

Sintering parameters and mechanical properties of injection moulded aluminium powder

By Acar L   Gülsoy H Ö  

Powder Metallurgy, Vol. 54, Iss. 3, 2011-07 ,pp. : 427-431

Maney Publishing

Access to resources Recommend Favorite

Properties of Injection Moulded Fe—Cu Parts Made from Composite and Elemental Powders

By Huang C. T.   Hwang K. S.  

Powder Metallurgy, Vol. 39, Iss. 2, 1996-01 ,pp. : 119-123

Maney Publishing

Access to resources Recommend Favorite

Microstructural and mechanical properties of injection moulded gas and water atomised 17-4 PH stainless steel powder

By Gülsoy H. Ö.   Özbek S.   Baykara T.  

Powder Metallurgy, Vol. 50, Iss. 2, 2007-06 ,pp. : 120-126

Maney Publishing

Access to resources Recommend Favorite

Effect of sintering parameters on mechanical properties of injection moulded Ti–6Al–4V alloys

By Ergül E.   Özkan Gülsoy H.   Günay V.  

Powder Metallurgy, Vol. 52, Iss. 1, 2009-03 ,pp. : 65-71

Maney Publishing

Access to resources Recommend Favorite