Impact of Innovative Cooling System on Mechanical Properties of Moulded Parts

E-ISSN： 1662-9507|2016|368|49-52

ISSN： 1012-0386

Source： Defect and Diffusion Forum, Vol.2016, Iss.368, 2016-08, pp. : 49-52

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Observation of Impact of Progressive Cooling System on Temperature Field Distributions on Surfaces of Injection Moulded Plastic Parts

Key Engineering Materials, Vol. 2015, Iss. 669, 2016-02 ,pp. : 19-28

Trans Tech Publications

Access to resources Recommend Favorite

Microstructure and mechanical properties of injection moulded Nimonic-90 superalloy parts

By Özgün Ö Gülsoy H Ö Findik F Yilmaz R

Powder Metallurgy, Vol. 55, Iss. 5, 2012-12 ,pp. : 405-414

Maney Publishing

Access to resources Recommend Favorite

Mechanical properties distributions of PM parts

By Newkirk J. W. Thakur S.

Powder Metallurgy, Vol. 45, Iss. 4, 2002-12 ,pp. : 354-358

Maney Publishing

Access to resources Recommend Favorite

Sintering parameters and mechanical properties of injection moulded aluminium powder

By Acar L Gülsoy H Ö

Powder Metallurgy, Vol. 54, Iss. 3, 2011-07 ,pp. : 427-431

Maney Publishing

Access to resources Recommend Favorite

Heating and Cooling Impact on Mechanical Properties of RIP Electric Insulator for High Voltage Inputs

Solid State Phenomena, Vol. 2017, Iss. 265, 2017-10 ,pp. : 496-500

Trans Tech Publications

Access to resources Recommend Favorite