Advanced nanomechanical testing for high speed machining of hard-to-cut aerospace alloys

Author： Beake B D   Fox-Rabinovich G S  

Publisher： Maney Publishing

ISSN： 1749-5156

Source： International Heat Treatment & Surface Engineering, Vol.5, Iss.1, 2011-03, pp. : 17-20

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Hard anodising of aerospace aluminium alloys

By Lerner L. M.  

Transactions of the Institute of Metal Finishing, Vol. 88, Iss. 1, 2010-01 ,pp. : 21-24

Maney Publishing

Access to resources Recommend Favorite

Wear Mechanisms of Hard-Brittle Material Tools in High-Speed Machining of Powder Metallurgy Material

By  

Key Engineering Materials, Vol. 2016, Iss. 693, 2016-06 ,pp. : 1200-1206

Trans Tech Publications

Access to resources Recommend Favorite

High-strength, corrosion-resistant aerospace aluminum alloys

By Frazier William  

JOM, Vol. 55, Iss. 1, 2003-01 ,pp. : 44-44

Springer Publishing Company

Access to resources Recommend Favorite

FEA-Based Comparative Investigation on High Speed Machining of Aluminum Alloys AA6061-T6 and AA7075-T651

By  

Solid State Phenomena, Vol. 2017, Iss. 261, 2017-09 ,pp. : 347-353

Trans Tech Publications

Access to resources Recommend Favorite

New Methodologies for Development of High Efficient Machining of Difficult to Cut Materials

By  

IOP Conference Series: Materials Science and Engineering, Vol. 26, Iss. 1, 2011-12 ,pp. : 46-50

IOP Publishing

Access to resources Recommend Favorite