New Methodologies for Development of High Efficient Machining of Difficult to Cut Materials

Publisher： IOP Publishing

ISSN： 1757-899X

Source： IOP Conference Series: Materials Science and Engineering, Vol.26, Iss.1, 2011-12, pp. : 46-50

Access to resources Favorite

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

High Speed Machining of Difficult-to-Machine Materials under Different Lubrication Conditions

By  

Key Engineering Materials, Vol. 2014, Iss. 625, 2014-10 ,pp. : 60-65

Trans Tech Publications

Access to resources Recommend Favorite

Research on the Influence of Tool Wear on Cutting Performance in High-Speed Milling of Difficult-to-Cut Materials

By  

Key Engineering Materials, Vol. 2016, Iss. 693, 2016-06 ,pp. : 1129-1134

Trans Tech Publications

Access to resources Recommend Favorite

Machinability Evaluation of Inclined Planetary Motion Milling System for Difficult-to-Cut Materials

By  

Key Engineering Materials, Vol. 2015, Iss. 656, 2015-08 ,pp. : 320-327

Trans Tech Publications

Access to resources Recommend Favorite

The Application and Performance of Diamond and PCBN Tools in Difficult-to-Cut Materials

By  

Solid State Phenomena, Vol. 2017, Iss. 263, 2017-10 ,pp. : 90-96

Trans Tech Publications

Access to resources Recommend Favorite

Advanced nanomechanical testing for high speed machining of hard-to-cut aerospace alloys

By Beake B D   Fox-Rabinovich G S  

International Heat Treatment & Surface Engineering, Vol. 5, Iss. 1, 2011-03 ,pp. : 17-20

Maney Publishing

Access to resources Recommend Favorite