Mechanical properties and shear failure surfaces for two alumina powders in triaxial compression

Author： Zeuch D.H. Grazier J.M. Argüello J.G. Ewsuk K.G.

ISSN： 0022-2461

Source： Journal of Materials Science, Vol.36, Iss.12, 2001-06, pp. : 2911-2924

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Mechanical properties of cement foams in shear

By Huang J-S. Liu K-D.

Journal of Materials Science, Vol. 36, Iss. 3, 2001-02 ,pp. : 771-777

Springer Publishing Company

Access to resources Recommend Favorite

Experimental Studying on Rock of HeLanKou Deformation and Failure Characteristics under Triaxial Compression Test

Advanced Materials Research, Vol. 2014, Iss. 1065, 2015-01 ,pp. : 40-43

Trans Tech Publications

Access to resources Recommend Favorite

Lateral stress measurements in a shock loaded alumina: Shear strength and delayed failure

By Millett J.C.F. Bourne N.K.

Journal of Materials Science, Vol. 36, Iss. 14, 2001-07 ,pp. : 3409-3414

Springer Publishing Company

Access to resources Recommend Favorite

Microstructure and properties of alumina-SiC nanocomposites prepared from ultrafine powders

By Sciti D. Vicens J. Bellosi A.

Journal of Materials Science, Vol. 37, Iss. 17, 2002-09 ,pp. : 3747-3758

Springer Publishing Company

Access to resources Recommend Favorite

Densification, mechanical and microstructure properties of β-spodumene—alumina composites

By Awaad M. Mörtel H. Naga S.

Journal of Materials Science: Materials in Electronics, Vol. 16, Iss. 6, 2005-06 ,pp. : 377-381

Springer Publishing Company

Access to resources Recommend Favorite