Author： Roncone Kelly
Publisher： Springer Publishing Company
ISSN： 1543-1851
Source： JOM, Vol.57, Iss.3, 2005-03, pp. : 11-13
Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.
Abstract
Related content
Influence of the Cutting Fluid on Tool Edge Temperature in End Milling of Titanium Alloy
Key Engineering Materials, Vol. 2015, Iss. 656, 2015-08 ,pp. :
Access to resources
Recommend
Air Jet Assisted End Milling of Titanium Alloy Ti-6Al-4V ELI at High Cutting Speed
Key Engineering Materials, Vol. 2015, Iss. 656, 2015-08 ,pp. :
Research on Milling Force in Ultrasonic Assisted End Milling of Titanium Alloy Thin-Walled Parts
Key Engineering Materials, Vol. 2018, Iss. 764, 2018-03 ,pp. :
Relationship between Cutting Heat and Tool Edge Temperature in End Milling of Titanium Alloy
Key Engineering Materials, Vol. 2017, Iss. 749, 2017-09 ,pp. :