Effect of specimen geometry, gage length, and width measurement locations on plastic strain ratio (R-value) in sheet metals

Author： Chamanfar A.   Mahmudi R.  

Publisher： Springer Publishing Company

ISSN： 1543-1940

Source： Metallurgical and Materials Transactions A, Vol.37, Iss.12, 2006-12, pp. : 3477-3487

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Ti sheet: The effect of gage length and width measurement on plastic strain ratio

By Chamanfar A.   Mahmudi R.  

JOM, Vol. 56, Iss. 2, 2004-02 ,pp. : 49-52

Springer Publishing Company

Access to resources Recommend Favorite

Influence of discontinuous yielding on normal anisotropy (R-value) measurements

By Hance Brandon  

Journal of Materials Engineering and Performance, Vol. 14, Iss. 5, 2005-10 ,pp. : 616-622

Springer Publishing Company

Access to resources Recommend Favorite

Determination of the Plastic Strain by Spherical Indentation of Uniaxially Deformed Sheet Metals

By  

Key Engineering Materials, Vol. 2015, Iss. 651, 2015-08 ,pp. : 950-956

Trans Tech Publications

Access to resources Recommend Favorite

The Effect of the Initial Stress and Strain State in Sheet Metals on the Roller Levelling Process

By  

Key Engineering Materials, Vol. 2015, Iss. 651, 2015-08 ,pp. : 1023-1028

Trans Tech Publications

Access to resources Recommend Favorite

Effect of Reversibility of Plastic Strain upon Reversed Cyclic Loading of Metals and Alloys

By Rybakova L.  

Metal Science and Heat Treatment, Vol. 47, Iss. 7-8, 2005-07 ,pp. : 366-370

Springer Publishing Company

Access to resources Recommend Favorite