The Effect of the Initial Stress and Strain State in Sheet Metals on the Roller Levelling Process

Publisher： Trans Tech Publications

E-ISSN： 1662-9795|2015|651|1023-1028

ISSN： 1013-9826

Source： Key Engineering Materials, Vol.2015, Iss.651, 2015-08, pp. : 1023-1028

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Effect of Pore Architecture of Titanium Implants on Stress-Strain State upon Compression

By  

Solid State Phenomena, Vol. 2017, Iss. 265, 2017-10 ,pp. : 606-610

Trans Tech Publications

Access to resources Recommend Favorite

Effect of specimen geometry, gage length, and width measurement locations on plastic strain ratio (R-value) in sheet metals

By Chamanfar A.   Mahmudi R.  

Metallurgical and Materials Transactions A, Vol. 37, Iss. 12, 2006-12 ,pp. : 3477-3487

Springer Publishing Company

Access to resources Recommend Favorite

Determination of the Plastic Strain by Spherical Indentation of Uniaxially Deformed Sheet Metals

By  

Key Engineering Materials, Vol. 2015, Iss. 651, 2015-08 ,pp. : 950-956

Trans Tech Publications

Access to resources Recommend Favorite

The effect of the hot air levelling process on skip solder defects in the wave soldering process

By Choon Teo Kiat  

Soldering & Surface Mount Technology, Vol. 15, Iss. 2, 2003-06 ,pp. : 28-34

Emerald Group Publishing Ltd

Access to resources Recommend Favorite

Influence Law of Initial Reverse Bulging on Sheet Hydroforming Process

By  

Key Engineering Materials, Vol. 2017, Iss. 746, 2017-08 ,pp. : 99-107

Trans Tech Publications

Access to resources Recommend Favorite