Potential and pH Measurements in a Crevice of the Steel BS 4360 50D in 3·5% NaCl and in Artificial Sea Water

ISSN： 0007-0599

Source： British Corrosion Journal, Vol.16, Iss.3, 1981-01, pp. : 140-144

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Steady state electrochemical kinetics of BS 4360 50D structural steel in deaerated 3·5%NaCl solution of varying pH

By Turnbull A. May A. T.

British Corrosion Journal, Vol. 22, Iss. 3, 1987-01 ,pp. : 176-181

Maney Publishing

Access to resources Recommend Favorite

Galvanic corrosion of gas tungsten arc repair welds in 17-4PH stainless steel in 3·5% NaCl solution

By Shoushtari M R Tavakoli Moayed M H Davoodi A

Corrosion Engineering, Science and Technology, Vol. 46, Iss. 4, 2011-06 ,pp. : 406-414

Maney Publishing

Access to resources Recommend Favorite

Post-weld heat treatment influence on galvanic corrosion of GTAW of 17-4PH stainless steel in 3·5%NaCl

By Tavakoli Shoushtari M R Moayed M H Davoodi A

Corrosion Engineering, Science and Technology, Vol. 46, Iss. 4, 2011-06 ,pp. : 415-424

Maney Publishing

Access to resources Recommend Favorite

Effect of sulphide pollutants on mild steel corrosion in 3·5% NaCl solutions

By Wang X. T. Hou B. R.

Corrosion Engineering, Science and Technology, Vol. 45, Iss. 1, 2010-02 ,pp. : 57-60

Maney Publishing

Access to resources Recommend Favorite

Technical note Influence of quarternary amine alkyl chain length on corrosion inhibition of mild steel in CO₂ saturated 5%NaCl solution at pH 6·5

By MALIK H.

British Corrosion Journal, Vol. 32, Iss. 2, 1997-01 ,pp. : 150-152

Maney Publishing

Access to resources Recommend Favorite