Annealing Twin Formation in a Cast and Annealed Cu-4 at.% Sn Alloy

ISSN： 0008-4433

Source： Canadian Metallurgical Quarterly, Vol.23, Iss.2, 1984-04, pp. : 237-240

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Non-isothermal annealing of a cold rolled commercial twin roll cast 3003 aluminum alloy

By Puchi-Cabrera E. Villalobos-Gutiérrez C. Carrillo A. Simone F.

Journal of Materials Engineering and Performance, Vol. 12, Iss. 3, 2003-06 ,pp. : 261-271

Springer Publishing Company

Access to resources Recommend Favorite

Cavitation Wear of CuZn10 Alloy in As-Cast State and after Plastic Working and Annealing

Solid State Phenomena, Vol. 2016, Iss. 252, 2016-08 ,pp. : 51-60

Trans Tech Publications

Access to resources Recommend Favorite

Influence of Annealing of Al-5Ti-1B Master Alloy on Hot Tearing of Cast Al-7Si-3Cu Alloy

Key Engineering Materials, Vol. 2017, Iss. 737, 2017-07 ,pp. : 27-31

Trans Tech Publications

Access to resources Recommend Favorite

Hot Cracking Susceptibility of Twin Roll Cast Al-Mg Alloy Welds

By Tirkeş Süha Batιgün Caner Ankara Alpay

Canadian Metallurgical Quarterly, Vol. 49, Iss. 1, 2010-01 ,pp. : 73-80

Maney Publishing

Access to resources Recommend Favorite

Directional Solidification in a AgCuSn Eutectic Alloy

By Schaefer Robert J. Lewis Daniel J.

Metallurgical and Materials Transactions A, Vol. 36, Iss. 10, 2005-10 ,pp. : 2775-2783

Springer Publishing Company

Access to resources Recommend Favorite