Investigation of surface roughness in micro-electro discharge machining of nonconductive ZrO2 for MEMS application

Publisher： IOP Publishing

ISSN： 1757-899X

Source： IOP Conference Series: Materials Science and Engineering, Vol.53, Iss.1, 2013-12, pp. : 728-732

Access to resources Favorite

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Electro Discharge Machining of AL2O3 Based Ceramic

By  

Key Engineering Materials, Vol. 2014, Iss. 625, 2014-10 ,pp. : 511-517

Trans Tech Publications

Access to resources Recommend Favorite

Microstructure, mechanical properties and machining performance of hot-pressed Al2O3 - ZrO2 - TiC composites

By  

IOP Conference Series: Materials Science and Engineering, Vol. 116, Iss. 1, 2016-02 ,pp. : 9-13

IOP Publishing

Access to resources Recommend Favorite

Material Removal Rate, Kerf, and Surface Roughness of Tungsten Carbide Machined with Wire Electrical Discharge Machining

By Shah Aqueel   Mufti Nadeem   Rakwal Dinesh   Bamberg Eberhard  

Journal of Materials Engineering and Performance, Vol. 20, Iss. 1, 2011-02 ,pp. : 71-76

Springer Publishing Company

Access to resources Recommend Favorite

Phase Diagram of the Al2O3 – ZrO2 – Nd2O3 System. Part 2. Liquidus Surface

By Lakiza Sergei M.   Lopato Lidiya M.  

Powder Metallurgy and Metal Ceramics, Vol. 43, Iss. 1-2, 2004-01 ,pp. : 44-49

Springer Publishing Company

Access to resources Recommend Favorite

Investigation of the structural–phase state of ultrafine plasmochemical ZrO2 (Y) powders

By  

IOP Conference Series: Materials Science and Engineering, Vol. 66, Iss. 1, 2014-10 ,pp. : 111-115

IOP Publishing

Access to resources Recommend Favorite