Publisher： John Wiley & Sons Inc
E-ISSN： 1439-2054|300|2|172-180
ISSN： 1438-7492
Source： MACROMOLECULAR MATERIALS & ENGINEERING, Vol.300, Iss.2, 2015-02, pp. : 172-180
Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.
Abstract
Related content
Insert injection molding of high‐density polyethylene single‐polymer composites
POLYMER ENGINEERING & SCIENCE, Vol. 32-3888, Iss. 11, 2015-11 ,pp. :
Access to resources
Recommend
Insert injection molding of high‐density polyethylene single‐polymer composites
POLYMER ENGINEERING & SCIENCE, Vol. 55, Iss. 11, 2015-11 ,pp. :
A simulation test for wear in injection moulding machines
Wear, Vol. 249, Iss. 5, 2001-06 ,pp. :
Estimation of Fibre Orientation in Injection Moulding Plastics Parts
Materials Science Forum, Vol. 2017, Iss. 891, 2017-04 ,pp. :
Low friction surfaces for plastic injection moulding dies-an experimental case study
Wear, Vol. 225, Iss. 2, 1999-04 ,pp. :