Morphological analysis of microcellular PP produced in a core‐back injection process using chemical blowing agents and gas counter pressure

Publisher： John Wiley & Sons Inc

E-ISSN： 1548-2634|32-3888|11|2465-2473

ISSN： 0032-3888

Source： POLYMER ENGINEERING & SCIENCE, Vol.32-3888, Iss.11, 2015-11, pp. : 2465-2473

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Morphological analysis of microcellular PP produced in a core‐back injection process using chemical blowing agents and gas counter pressure

By  

POLYMER ENGINEERING & SCIENCE, Vol. 55, Iss. 11, 2015-11 ,pp. : 2465-2473

John Wiley & Sons Inc

Access to resources Recommend Favorite

Computer Analysis of Polyolefins Produced with Injection Molding Process Using Physical Blowing Agents

By  

Materials Science Forum, Vol. 2018, Iss. 919, 2018-05 ,pp. : 299-306

Trans Tech Publications

Access to resources Recommend Favorite

Microcellular Foam Injection Molding of Thermoplastics Using Green Physical Blowing Agent

By  

Materials Science Forum, Vol. 2016, Iss. 875, 2016-11 ,pp. : 77-111

Trans Tech Publications

Access to resources Recommend Favorite

Novel foaming method to fabricate microcellular injection molded polycarbonate parts using sodium chloride and active carbon as nucleating agents

By  

POLYMER ENGINEERING & SCIENCE, Vol. 55, Iss. 7, 2015-07 ,pp. : 1634-1642

John Wiley & Sons Inc

Access to resources Recommend Favorite

Fabrication of highly expanded thermoplastic polyurethane foams using microcellular injection molding and gas‐laden pellets

By  

POLYMER ENGINEERING & SCIENCE, Vol. 32-3888, Iss. 11, 2015-11 ,pp. : 2643-2652

John Wiley & Sons Inc

Access to resources Recommend Favorite