Novel foaming method to fabricate microcellular injection molded polycarbonate parts using sodium chloride and active carbon as nucleating agents

Publisher： John Wiley & Sons Inc

E-ISSN： 1548-2634|55|7|1634-1642

ISSN： 0032-3888

Source： POLYMER ENGINEERING & SCIENCE, Vol.55, Iss.7, 2015-07, pp. : 1634-1642

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Process‐induced phase and crystal morphologies in water‐assisted injection molded polypropylene/polymeric β‐nucleating agent blend parts

By  

POLYMER ENGINEERING & SCIENCE, Vol. 55, Iss. 7, 2015-07 ,pp. : 1698-1705

John Wiley & Sons Inc

Access to resources Recommend Favorite

Flowing simulation of injection molded parts with micro-channel

By Cui Zhi-xiang   Si Jun-hui   Liu Chun-tai   Shen Chang-yu  

Applied Mathematics and Mechanics, Vol. 35, Iss. 3, 2014-03 ,pp. : 269-276

Springer Publishing Company

Access to resources Recommend Favorite

Morphological analysis of microcellular PP produced in a core‐back injection process using chemical blowing agents and gas counter pressure

By  

POLYMER ENGINEERING & SCIENCE, Vol. 32-3888, Iss. 11, 2015-11 ,pp. : 2465-2473

John Wiley & Sons Inc

Access to resources Recommend Favorite

Morphological analysis of microcellular PP produced in a core‐back injection process using chemical blowing agents and gas counter pressure

By  

POLYMER ENGINEERING & SCIENCE, Vol. 55, Iss. 11, 2015-11 ,pp. : 2465-2473

John Wiley & Sons Inc

Access to resources Recommend Favorite

Optimization and numerical simulation analysis for molded thin‐walled parts fabricated using wood‐filled polypropylene composites via plastic injection molding

By  

POLYMER ENGINEERING & SCIENCE, Vol. 55, Iss. 5, 2015-05 ,pp. : 1082-1095

John Wiley & Sons Inc

Access to resources Recommend Favorite